Table of Contents
Advertisement
Shutter Sync Settings:
1.
High-speed sync: press the <SYNC> button until
displayed on the panel. Then, set the camera shutter.
2.
Rear curtain sync: press the <SYNC> button until
displayed on the panel. Then, set the camera shutter.
● With high-speed sync, the faster the shutter speed, the
shorter the effective flash range.
● Multi flash mode cannot be set in high-speed sync mode.
● Over-temperature protection may be activated after 15
consecutive high-speed sync flashes.
● Try to avoid using high-speed sync flash, which will cut
short flash tube's lifetime.
- 37 -
Flash Mode – M: Manual Flash
is
The flash output is adjustable from 1/1 full power to 1/128th power
in 1/3rd stop increments. To obtain a correct flash exposure, use a
hand-held flash meter to determine the required flash output.
is
MODE
Flash Output Range
The following table makes it easier to see how the stop changes in
terms of f/stop when you increase or decrease the flash output. For
example, when you decrease the flash output to 1/2, 1/2-0.3, or 1/2-
0.7, and then increase the flash output to more than 1/2, 1/2+0.3,
1/2+0.7, and 1/1 will be displayed.
1/1
In the M mode,
can be achieved.
In M manual flash mode, press the <SLAVE> button so that this
flash can function as an optic S1 secondary flash with optic sensor.
With this function, the flash will fire synchronously when the main
flash fires, the same effect as that by the use of radio triggers. This
helps create multiple lighting effects.
Press the <SLAVE> button so that this flash can also function as an
optic S2 secondary flash with optic sensor in M manual flash mode.
This is useful when cameras have pre-flash function. With this
function, the flash will ignore a single "preflash" from the main flash
and will only fire in response to the second, actual flash from the
main unit.
S1 and S2 optic triggering and off camera high-speed
●
mode are only available in M manual flash mode.
1
Press < MODE > button so
ZOOM
SYNC
SLAVE
that < M > is displayed.
MODE
ZOOM
SYNC
SLAVE
SET
2
Turn the Select Dial to choose
SET
a desired flash output amount.
In
the adjustable flash range is
1/16~1/1.
Figures displayed when reducing flash output level
1/1-0.3
1/1-0.7
1/2-0.3
1/2
1/2+0.7
1/2+0.3
1/4+0.7
Figures displayed when increasing flash output level
high-speed sync and rear curtain sync functions
Optical S1 Secondary Unit Setting
Optical S2 Secondary Unit Setting
high-speed sync mode,
······
1/2-0.7
1/4
1/4+0.3
······
- 38 -
Advertisement
Table of Contents
