Table of Contents
Advertisement
3. Whether the distance between the flash trigger and the flash
is too close or not
→Please turn on the "close distance wireless mode" on the flash trigger
(＜0.5m):
X1 series: press the test button and hold on, then turning it on until the flash
ready indicator blinks for 2 times.
XPro series: Set the C.Fn-DIST to 0-30m.
4. Whether the flash trigger and the receiver end equipment are in the low
battery states or not
→Please replace the battery(the flash trigger is recommended to use 1.5V
disposable alkaline battery).
Other Applications
Auto Focus Assist Beam
Long press the C.Fn to enter C.Fn custom settings and press SET
button: choose "ON" or "OFF" to turn on or off the to the AF-assist
beam function . When turning on the AF-assist beam function: the
red AF-assist lamp will light when it's hard to focus while
automatically off when getting correct focus.
●
When not attaching to the camera, the auto focus assist
beam of V350C does not light up.
Position
Effective Range
Center
0.6~4m
Periphery
0.6~2.5m
Bounce Flash
By pointing the flash head toward a wall or ceiling, the flash will
bounce off the surface before illuminating the subject. This can
soften shadows behind the subject for a more natural-looking shot.
This is called bounce flash.
To set the bounce direction, hold the flash head and turn it to a
satisfying angle.
270
- 45 -
-7-90
If the wall or ceiling is too far away, the bounced flash might
●
be too weak and result in underexposure.
●
The wall or ceiling should be a plain, white color for high
reflectance. If the bounce surface is not white, a color cast
may appear in the picture.
Creating a Catchlight
With the catchlight panel, you can create a catchlight in the subject's
eyes to add life to the facial expression.
1
2
3
Point the flash head straight ahead and then upward by 90°.
●
The catchlight will not appear if you swing the flash head left
or right.
●
For best catchlight effect, stay 1.5m/4.9ft away from the
subject.
ZOOM: Setting the Flash Coverage and Using
the Wide Panel
The flash coverage can be set automatically or manually. It can be
set to match the lens focal length from 24mm to 105mm. Also, with
the built-in wide panel, the flash coverage can be expanded for
14mm wide-angle lenses.
MODE
ZOOM
SYNC
SLAVE
SET
If you set the flash coverage manually, make sure it covers
●
the lens focal length so that the picture will not have a dark
periphery.
●
When the low battery indicator is displayed, the ZOOM can
not be adjusted, it will constantly be 24mm.
Point the flash head upward by
90°.
Pull out the wide panel. The
catchlight panel will come out
at the same time.
Push the wide panel back in.
Push in only the wide panel.
●
●
Follow the same procedures
as for bounce flash.
In Manual Zoom mode, press the
<ZOOM> button.
Turn the Select Dial to change
●
the flash coverage.
●
If <
AU
> is displayed, the flash
coverage will be set
automatically.
- 46 -
Advertisement
Table of Contents
