Operating Procedures - Toshiba TEC EO1-32003 Owner's Manual

13. OPERATING PROCEDURES

13. OPERATING PROCEDURES
■
NOTES BEFORE STARTING OPERATION
(1) Turn the power ON.
(2) A sixteen-second scanning will be performed after pressing the
(3) Should a power failure occur during the operation, remove the commodity from the platter
and insert the power plug into an AC outlet again when power is restored.
(4) If the scale is used with an unrated power source, inaccurate scaling or other errors may
occur.
(5) If the zero point has shifted while scaling, and no tare is displayed, adjust the zero point
by pressing the
(6) Check the date of the scale before the daily operation.
(7) Make a test print before operation every day.
Press the
■
How to access REG., M.DOWN, or REWRAP menu
The following display is displayed on the REG. menu display. When this display is shown
after pressing the
<REG.> MENU
ENTER THE PLU#
To access a menu from other menus, press the
the menu No. When the MARK DOWN and REWRAP menus are protected, enter the menu
No. and then the password.
<Menu> MAIN
0. PROG.
1. REG.
2. MARK DOWN
3. REWRAP
4. SECURITY
NOTE: If a label nothing is printed on is issued after a printed label in batch mode, refer to
Section 10.11 and press the
ZERO key.
TEST
key, and the test label is issued.
key, you can start the REG. operation right away.
POWER
WEIGH
lb UNIT/$
0.000
5. READ
6. RESET
7.
8.
9.
TOTAL $
P 000000
ESC.
key to show the Main menu and enter
SET NEXT
key.
13- 1
■ NOTES BEFORE STARTING OPERATION
POWER
key.