Table of Contents
Advertisement
10. PROGRAMMING PROCEDURES
10.18 TRANSFERRING LOGO DATA
Menu Page: 2
Item No.:
8
Logo data is created on a PC and stored into RAM through the CMT interface. Two different sizes of
logos, 320×118 dots and 256×64 dots, are available on the H-9100N series. 64 KB of RAM area is
secured for logo data, in which the maximum of 13 logos (320×118 dots) or 26 logos (256×64 dots)
can be stored.
Before starting the following operation, set the initial setting #10-7 to 1.
<MENU>
Page 2
NOTE: Two sizes of logos are printed differently as follows:
Print LOGO
(320 x 118 dots)
Display LOGO
(256 x 64 dots)
: Logo data
: Print/Display area
Load a tape into
8
the CMT Loader
ENTER
PROG.
ESC.
<Display>
64
256
(Part of LOGO is
displayed.)
Select a transmission item.
1: SAVE (H-9100N→CMT)
2: VERIFY (H-9100N=CMT)
3: LOAD (H-9100N←CMT)
<MENU>
Page 2
Main
<MENU>
<Label>
1st LOGO
160
80
2nd LOGO
(Part of LOGO is
printed.)
104
118
64
256
FSP LOGO
(Part of LOGO is
overlapped with
FSP print area.)
1st LOGO
(LOGO is printed on the
center of printing area.)
160
64
2nd LOGO
(Part of LOGO is
printed.)
FSP LOGO
(LOGO is printed on
part of FSP print
area.)
10-29
10.18 TRANSFERRING LOGO DATA
<Receipt>
(LOGO #1 & half of LOGO
#2 are printed.
Advertisement
Table of Contents
