Table of Contents
Advertisement
10. PROGRAMMING PROCEDURES
10.11 PRINT FORMAT
Menu Page: 2
Item No.:
0
The H-9100N can memorize 5 different print formats. After the print formats are set, you can call
them by pressing the print format number.
<MENU>
Page 2
CHANGE
Issue method
PLU
Batch
Select the Item for
adjustment.
1 gradation
=0.154 mm (1 dot)
1 gradation
=0.462 mm (3 dots)
1 gradation
=0.462 mm (3 dots)
Only when using the bar code
change label with pre-feed area.
(This adjustment cannot be made
on the Variable Length Label.)
NOTES:
1. When a commodity name position is adjusted, an address position will move automatically.
2. When entering the other label format #, fine adjust values are initialized.
3. Selecting label format numbers other than those provided in Table 2 results in an error.
4. When selecting a variable length label format, rectangles are printed instead of print items in
the case of the test printing.
5. Pressing the
6. Be sure to press the
selected.
Select the print format # which
allocates the label format #
0
by the
NEXT PLU
On-demand
Select "SENSITIVITY ADJUST"
by pressing the
key.
◇
When Batch Printing with backing paper is
selected, the sensitivity of the label sensor will be
set by pressing the
SET NEXT
issuing label.
◇
Enter the correct label feed
value.
(Range: 0 to 199)
Enter the correct value for
commodity name position.
(Range: 0 to 9)
Enter the correct value for
address position.
(Range: 0 to 15)
Enter the correct value for
pre-feed area.
(Range: 0 to 65)
◇
key allows you to select a print format number from 1 to 5.
SET NEXT
key when a label format for batch printing with backing paper is
Enter the label format #.
(Refer to table 2)
key or
key.
SET
NEXT
key before
ENTER
ENTER
ENTER
ENTER
10-18
10.11 PRINT FORMAT
j
position
TEST
FEED
correct?
Incorrect
j
<MENU>
j
j
j
Correct
Is print
CHANGE
PLU
PROG.
Page 2
Main
ESC.
<MENU>
Advertisement
Table of Contents
