Table of Contents
Advertisement
10. PROGRAMMING PROCEDURES
7. Tare % indicates a percentage of tare in gross weight, which is available when the Initial Setting
#28-4 is set to 1.
8. When setting open prices in the count mode (Initial Setting #1-6: 1), set zeros as quantity and
unit price.
10.3 INGREDIENT MESSAGE
Menu Page: 1
Item No.:
2
Ingredient messages can be printed on a label with a maximum of 54 characters per line using small
letters or 32 characters per line using boldfaced small letters by up to 38 lines.
<MENU>
Page 1
Enter the ingredient message
(Refer to Page 10-3.)
Pressing the
calls data stored by pressing
the
SEND
Pressing the
temporarily stores data into
the work buffer.
NOTES: 1. When no data is programmed for the PLU, ingredient cannot be set.
2. When a selected PLU is not stored in the PLU file, a "PLU NOT FOUND" error occurs.
3. Once you exit this menu and enter again, data stored in the work buffer is cleared.
4. When there is no area to store ingredient data, a "MEMORY FULL" error occurs.
5. Different PLUs cannot use the same ingredient data. (PLU and ingredient data are in
pairs.)
c
Enter the PLU#
2
NEXT
or
PLU
key
RECEIVE
key.
key
SEND
(max. 6 dig.)
ENTER
TEST
◇
Y
Any key
except Y
The memory file
is sorted when a
memory full error
occurs.
10- 7
10.3 INGREDIENT MESSAGE
ENTER
c
<MENU>
PROG.
ESC.
<MENU>
Sorting
Not Sorting
Page 1
Main
Advertisement
Table of Contents
