Table of Contents
Advertisement
POWER SUPPLY CORD SELECTION
If your line voltage is 220 to 240V, use one of the following types of cable.
Plug
configuration
Use a 5A fuse which is approved by ASTA
or BSI to BSI362.
Always replace the fuse cover after changing
the fuse.
IMPORTANT PRECAUTIONS
Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have to
ship your projector. For maximum protection, repack the set as it was originally packed at
the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm location.
When the unit is exposed to such a change in temperature, moisture may condense on the
crucial internal parts. To prevent the unit from possible damage, do not use the unit for at
least 2 hours when there is an extreme or sudden change in temperature.
Place and Manner of Installation
• Do not place in hot locations, such as near heating equipment. Doing so could cause mal-
function, and shorten the life of the projector.
• Avoid locations with oil or cigarette smoke. Doing so will dirty the optical parts, shortening
their lives, and darkening the screen.
• Do not use in angle of 20 or more degrees. Doing so could shorten the life of the lamp.
• If used at high altitudes, the unit could cease operation even if used within the rated tempera-
ture range. This is because the thinner air at high altitudes decreases the internal cooling
efficiency. Therefore, please lower the ambient temperature if using at high altitudes.
8
Plug type
Line voltage
EURO
220 – 240V
UK
220 – 240V
Plug
configuration
Plug type
Australian
240V
10A
Switzerland 200 – 240V
240V
6A
North
American
240V
15A
Line voltage
200 – 240V
Advertisement
Table of Contents
