Power Supply Cord Selection; Important Precautions - Toshiba TLP-X4500 User Manual

Before Using (continued)
Before Using (continued)

POWER SUPPLY CORD SELECTION

If your line voltage is 220 to 240V, use one of the following types of cable.
Plug
configuration Plug type
EURO
UK
Use a 5A fuse which is approved by ASTA
or BSI to BSI362.
Always replace the fuse cover after
changing the fuse.

IMPORTANT PRECAUTIONS

Save Original Packing Materials
The original shipping carton and packing materials will come in handy if you ever have
to ship your LCD projector. For maximum protection, repack the set as it was originally
packed at the factory.
Moisture Condensation
Never operate this unit immediately after moving it from a cold location to a warm
location. When the unit is exposed to such a change in temperature, moisture may
condense on the crucial internal parts. To prevent the unit from possible damage, do not
use the unit for at least 2 hours when there is an extreme or sudden change in
temperature.
Place and Manner of Installation
• Do not place in hot locations, such as near heating equipment. Doing so could cause
malfunction, and shorten the life of the LCD panel.
• Avoid locations with oil or cigarette smoke. Doing so will dirty the LCD panel and other
optical parts, shortening their lives, and darkening the screen.
• Do not use in angle of 20° or more degrees. Doing so could shorten the life of the
lamp.
• If used at high altitudes, the unit could cease operation even if used within the rated
temperature range. This is because the thinner air at high altitudes decreases the
internal cooling efficiency. Therefore, please lower the ambient temperature if using at
high altitudes.
Plug
configuration
Line voltage
220 - 240V
220 - 240V
Plug type
Line voltage
Australian 200 - 240V
240V
10A
Switzerland
200 - 240V
240V
6A
North American 200 - 240V
240V
15A
7