Checking Accessories; Inserting The Dry Batteries Into The Remote Controller - Toshiba TDP-MT500 Owner's Manual

Toshiba projector tdp-mt500 owner's manual
Hide thumbs Also See for TDP-MT500:
Table of Contents

Advertisement

PREPARATION

Checking accessories

The following accessories are provided with this projector. Check to be sure that all the accessories are packed in
the package.)
Power supply parts
Power cable
Conversion adaptor
Personal computer parts
D-SUB 9P
Mini DIN 8P
RS-232C cable
The attached power cable and conversion adaptor are to be used exclusively for this product. Never use them
for other products.

Inserting the dry batteries into the remote controller

1
2
Correctly treat the batteries after thoroughly reading "On treating the batteries" described on Page 7.
If the batteries are treated incorrectly, they may cause fire or peripheral contamination due to leakage
of the liquid, heating, or burst. (Read the cautions indicated on the battery, too.)
This projector is designed as plug-in equipment. There must be an easily accessible power outlet near
the installed projector.
Use the attached power cord with this projector. Using any other power cord than specified could
cause electromagnetic interference to radio or television broadcast.
Use the attached mini D-SUB 15pin-DVI conversion cable and RS-232C cable to suppress the inter-
ference within the restriction for J55022 class-B apparatus.
Use a DVI shielded cable to suppress the interference within the restriction for J55022 class-B appa-
ratus.
Be sure to connect this projector to a ground.
Remote controller parts
Video parts
Mini D-SUB 15P
DVI
Mini D-SUB 15P DVI-conversion cable
1. Remove the rear lid of the remote controller.
2. Check the polarity (+), (-) of the dry batteries, and set
3
them correctly inserting their (-) side first.
If the battery is inserted from the (+) side first, inserting
the (-) side is difficult because the coil spring end hits on
the battery side. If the battery is forced to insert in this
way, the outer label of the battery may get ripped and it
may cause short-circuit and heating.
3. Attach the rear lid.
Use two size-AAA dry batteries (RO3).
Exchange the two batteries to new ones if the distance
that allows the remote controller to operate becomes
shorter than usual.
Remote controller
Others
• Lens cap (Attached to the main body)
• Soft carrying case
• Operation manual
• Regular user card
• Warranty card
• Remote controller photo-sensor
protection sticker
Size-AAA
dry batteries (two)
11

Advertisement

Table of Contents
loading

Table of Contents