A1.3.2 Detection Area Of The Transmissive Sensor; A1.3.3 Detection Area Of The Reflective Sensor - Toshiba B-SV4T-GS10-QM Owner's Manual

APPENDIX 1 SPECIFICATIONS
A1.3.1 Media Type (Cont.)
Item
Width including backing paper
Media width
Media pitch
Media length
Gap length (or black mark length)
Black mark width
Thickness
Max. outer roll diameter
Roll direction
Inner core diameter
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC approved media.
2. When using a media roll of 76.2-mm (3") inner core diameter, the 3"-Diameter Media Shaft included in the
optional External Media Roll Hanger is required.

A1.3.2 Detection Area of the Transmissive Sensor

The Transmissive Sensor is positioned 6 mm from the centre.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Area to be detected.
Sensor position
Min. 2 mm
(Min. 6 mm:
cut mode)
Min. 8 mm

A1.3.3 Detection Area of the Reflective Sensor

The Reflective Sensor is movable within the full range of the media width.
The reflection factor of the Black Mark must be 10% or lower with a waveform length of 950 nm.
The Reflective Sensor should be aligned with the centre of the Black Mark.
Sensor should be positioned at the
centre of the black mark.
Min. 2 mm
(Min. 6 mm:
Cut mode)
Issue mode
Batch mode
10 to 1000(0.39 to 39.3)
Min. 10 (0.39)
Ø214 (8.4): When the optional External Media Roll Hanger is used.
Centre of media
Label
Gap
Label
Min. 8 mm
Sensor is movable within the full range.
EA1- 3
Strip mode
25.4 to 112 (1.0 to 4.4)
Min. 17 (0.7)
25.4 to 1000 (1.0 to 39.3)
Min. 2
Min. 8
0.06 to 0.19
Ø127 (5)
Either is acceptable.
Outside roll media; Linerless paper (option)
25.4, 38.1, or 76.2 (1, 1.5, or 3)
Sensor position
Media feed direction
6 mm
Media feed direction
ENGLISH VERSION
A1.3 Media
Unit: mm (inch)
Cut mode
Min. 25.4 (1.0)
Min. 6
(See NOTE 2.)
Print side
Detecting the black marks on
the back.