Toshiba B-SV4T-GS10-QM Owner's Manual page 20

2. PRINTER SETUP
2.8.2 Self Print Test and
Dump Mode (Cont.)
NOTE:
The following commands should
not affect the test print issue.
D, AX, XS, Z2;1, Z2;2 (without
AY)
2.8 Media Sensor Calibration, Self Print Test, and Dump Mode Utilities
PRINTER INFO.
PROGRAM VERSION
TONE ADJUST
FEED ADJUST
CUT POSITION ADJUST
BACKFEED ADJUST
PARAMETER
X-COORDINATE ADJUST
SENSOR
MEMORY
TTF AREA
EXT CHAR AREA
BASIC AREA
PC SAVE AREA
INFORMATION
TOTAL FEED
The test print contents should be changed by the following commands
and parameters:
PROGRAM VERSION: VX.XX XXXX --- Firmware version and checksum
TONE ADJUST: +XX ------------------------- Print tone fine adjustment value
FEED ADJUST: +XX.Xmm ------------------ Print position fine adjustment value
CUT POSITION ADJUST: +XX.Xmm ----- Cut position fine adjustment value
BACKFEED ADJUST: +XX.Xmm ---------- Back feed amount fine adjustment value
PARAMETER: [PC-850][0] ----------------- Character code selection and Font "0"
[9600][8][1][NONE][0]
[ON][AUTO][FEED][B0]
X-COORDINTE ADJUST: +XX.Xmm ----- X-coordinate fine adjustment value
SENSOR: TRANSMISSIVE [17] ------------ Sensor selection and sensitivity
MEMORY: [192KB][XXXKB]--------------- Memory capacity of the Main PC Board and
TTF AREA: [XXXKB][XXXKB]------------ True type font storage area, Main PC board
EXT CHAR AREA: [XXXKB][XXXKB] -- Writable character storage area, Main PC
BASIC AREA: [XXXKB][XXXKB] -------- BASIC file storage area, Main PC board and
PC SAVE AREA: [XXXKB][XXXKB] ----- PC save storage area, Main PC board and
INFORMATION: ------------------------------- Printed only when some information is
TOTAL FEED----------------------------------- Total feed distance
E2-11
Print test label sample
VX.XX XXXX
+XX
+XX.Xmm
+XX.Xmm
+XX.Xmm
[PC-850][0]
[9600][8][1][NONE][0]
[ON][AUTO][FEED][B0]
+XX.Xmm
TRANSMISSIVE [17]
[192KB][XXXKB]
[XXXKB][XXXKB]
[XXXKB][XXXKB]
[XXXKB][XXXKB]
[XXXKB][XXXKB]
XXXXXXXXXXXXXXXXXXX
X.XXKm
selection
Baud rate, Data length, Stop bit length,
Parity, and Transmission control of RS-
232C
Forward feed wait function, Control code,
Feed key function, and Euro code
optional memory card (0,1,2,3,4,6,8)
and optional memory card
board and optional memory card
optional memory card
optional memory card
stored in the flash ROM
ENGLISH VERSION