Toshiba Tosvert RS485 Instruction Manual page 47

Communication command2
This command is enabled only when the communication command is enabled. Set Bit 15 of Com-
munication Command 1 (communication Number: FA00, FA04) to "1" (enable). When enabling the
communication command by Communication Command 1, commands by communication can be
given the priority irrespective of the setting of the command mode selection parameter ().
However, if "48 (49): Forced switching from communication to local," "56 (57): Forced continuous
operation," or "58 (59): Specified speed operationj" is set by input terminal function selection
( to ), the enabled command and frequency will be given the priority.
Once enabled, this setting will be enabled till disable is set (0 setting), power is turned off or is reset,
or factory default setting () is selected.
Table 2 Data construction of communication command 2 (FA20, FA22)
Bit
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Note: The acceleration/deceleration change command ORs with Bit 6 of Communication number
FA00 and FA04.
Set Bit 6 of FA00 and FA04 to "0" and use FA20 and FA22 when changing acceleration/deceleration
in four types. Acceleration/deceleration 4 will be set when both Bit 8 of Communication number
FA20 and FA22 (or Bit 6 of Communication number FA00 and FA04) and Bit 9 of Communication
number FA20 and FA22 are set.
(Communication Number : FA20, FA22)
Function
Control switching
electric power quantity
reset
(Reserved)
Braking request (BC)
Preliminary excitation
Brake release (B)
Braking answer (BA)
Maximum deceleration
forced stop
Acceleration/deceleration
pattern selection 1
Acceleration/deceleration
pattern selection 2
V/Fswitching 1
V/Fswitching 2
Torque limit switching 1
Torque limit switching 2
Speed gain 1/2
(Reserved)
0 1
Speed control Torque control
Reset
ＯＦＦ
− −
Normal Forcibly braked
Normal Enabled
Brake applied Brake released
Brake applied Brake released
Normal Enabled
00: Acceleration/deceleration 1
01: Acceleration/deceleration 2
10: Acceleration/deceleration 3
11: Acceleration/deceleration 4
00: V/F 1
01: V/F 2
10: V/F 3
11: V/F 4
00: Torque limit 1
01: Torque limit 2
10: Torque limit 3
11: Torque limit 4
Gain 1 Gain 2
− −
46
E6581315
Remarks
Electric power quantity
(FE76, FE77) reset
Select Acceleration/ de-
celeration 1 - 4 by combi-
nation of two bits
AD1: , 
AD2: , 
AD3: , 
AD4: , 
Select V/F 1 - 4 by combi-
nation of two bits
Select torque limit 1 - 4 by
combination of two bits
Gain 1: , 
Gain 2: , 