Table of Contents
Advertisement
12
Close the front cover with the key.
13
Turn the TeraStation off first, then turn it on while holding down the mode button.
14
"RAID-0 NORMAL" will be displayed on the LCD panel.
RAID-0
NORMAL
15
Create a RAID volume. Refer to the "Creating a RAID Volumes" section in chapter 3.
For RAID 6 Volume:
1
Open the front cover with the included key.
2
Verify the status LEDs. The LED for the failed drive glows amber.
Do not unplug and remove the hard drives with the status LED lit green. If you do, it may cause data loss or
the unit to malfunction.
3
Remove the two defective hard drive cartridges whose status LED glow amber from the unit.
Leave the hard drives that the status LEDs blink amber in the unit.
4
Turn off the TeraStation.
5
Turn on the unit while holding down the mode button with the hard drives left removed.
6
When "RAID-6 TWO DRIVE DOWN" is displayed, replace the defective drive, referring to the ""TWO DRIVE
DOWN" Is Displayed on the LCD Panel" section above.
If "SYSTEM DOWN" is still displayed, go to the next step to replace the defective drive.
7
Remove another defective hard drive cartridges whose status LED glows amber.
8
Remove hard drives from the cartridges and install new hard drives in them.
9
Insert the new drive into all empty slots, slide the drive in with the locking mechanism open, and swing the
lock back down until it clicks into the place.
91
Advertisement
Table of Contents
