Buffalo TeraStation WSH5610DN2 User Manual page 7

8
Mode Button
Not in use normally; if the TeraStation beeps, press this button to stop the beeping.
9
Select Button
Not in use normally.
10
Drive Lock
Open the front panel with the key to replace hard drives or press the reset button.
11
Reset Button
To shut down and reboot the TeraStation, hold down the reset button. Do not press this button normally.
12
Status LEDs
Normally, these LEDs blink green when hard drives are accessed. If a drive fails or dismounts, its LED will turn
amber.
13
VGA Port
You can connect a VGA monitor to this port. Connecting a monitor directly to the TeraStation is only supported
for monitoring the progress of Windows Update.
14
HDMI Port
You can connect a HDMI monitor to this port. Connecting a monitor directly to the TeraStation is only
supported for monitoring the progress of Windows Update.
15
eSATA Port
eSATA-compatible hard drives are available with this port. Turn the TeraStation off before connecting the
drives.
16
UPS Port
Connect to a UPS.
17
USB 3.0 Port
Compatible Buffalo USB 3.0 hard drives, USB memory devices, and USB UPSs can be connected. USB hubs are
not supported.
18
USB 2.0 Port
Compatible Buffalo USB hard drives, USB memory devices, and USB UPSs can be connected. USB hubs are not
supported.
19
LAN Port 2
This second Ethernet port may be used for network redundancy or backup. You may connect a second
TeraStation directly to this port for backup.
20
LAN Port 1
Use an Ethernet cable to connect this port to your network.
21
Power Connector
Use the included power cable to connect to an UPS, surge protector, or outlet.
22
Fan
Spins to avoid overheating inside. Do not block the fan.
23
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
6