Table of Contents
Advertisement
Web screen configurations (continued)
<NOTE>
• After the [Execute] button is pressed, the amount of time it takes for
the version upgrade progress bar to appear is about 1 minute for the
Camera Main software or about 3 minutes for the Network software
or AVIO FPGA. The progress bar wil appear within 1 minute for other
firmware.
• Use the personal computer on the same subnet as the camera to
upgrade the software version.
• Before using the version upgrading software, be absolutely sure to
check the precautions to be observed with your dealer, and follow the
dealer's instructions.
• Use the following files specified by Panasonic Corporation as the
software used for version upgrading.
CPU Software Interface
.sif files
CPU Software Camera
.scm files
Main
CPU Software Servo
.spt files
CPU Software Network
.snw files
EEPROM Interface
.eep files
FPGA Lens
.fls files
FPGA AVIO
.fav files
• Do not turn off the unit's power while upgrading a software version.
(Do not turn off the power until the progress bar display is cleared.)
• While a software version is being upgraded, do not attempt to execute
any other operations until the version has been upgraded.
Status confirmation screen [Status]
„
„
Confirm the status of the unit.
z UPnP
„
Port number (HTTP)
Displays the port number configured via UPnP port forwarding.
Status
Displays the port forwarding status.
Port number (HTTPS)
Displays the port number configured via UPnP port forwarding.
Status
Displays the port forwarding status.
Router global address
Displays the global address of the router.
99
Advertisement
Table of Contents
