Table of Contents
Advertisement
NVR User Manual
3． Drag and draw the area for motion detection by left mouse.
Note:Check Clear checkbox and If you clear the area, then drag and draw the area for
motion detection by mouse.
4． Click the OK button to save and exit the window.
Step6
Select the Sensitivity from the drop-down box list. And then you can enable the detection
area.
You can drag the time bar to select the detection interval and record time.
Parameter
Sensitivity
Detection Interval
Record Time
（ Second）
Step7
Click Save button to take effect.
When the motion has been detected during the detection time in the detection area, the
NVR will alarm and adopt the corresponding alarm linkage.
Note: You must set the detection area and detection schedule, or else there is no alarm
anywhere and anytime.
-------End
【 Other Alarm】
Choose "Menu > Settings > Alarm Settings > Other Alarm" in the Menu interface. The
Other Alarm interface is displayed. You can configure the HDD(Hard Disk Drive)
information.
Description
The higher the sensitivity, the NVR will be more easily alarmed.
The Triggered Interval time between two motion detection. The unit is
second.
When you check the Record, you need to configure motion
detection recording time. The unit is second.
46
Advertisement
Table of Contents
