Machine Operation - ITC T-30C Operation Manual

6. MACHINE OPERATION

OPERATION ATTENTION
1. When the peak indicator in panel (red) power on, it
means that the signal output is in distortion. The rea-
sons are that: if all the electronic tube power on, it
means input signal is too big, please turn it down: if
not all the ones power on, it means output overload,
please check the wire input.
2. The machine will start automatically in 3 seconds,
meanwhile the protective tube power on, if test in good
condition, the indicator will power off .If all the time in
protective condition, it means something wrong with
machine, please contact with distributor.
3. Do not power on frequently, restart machine in 10
seconds.
4. Connect amplifier power in correctly with certain figure
sheet.
5. Cover has been connected with ground wire and the jack
should be injected correctly with electronic network.
6. When the signal input is strongly impacted,(etc lightning),
amplifier will analyze it cutting off signal automatically ,
check itself and restart.
7. With mic 1complusively broadcast, amplifier will auto-
matically put other signal input into mute control and the
signal will recover in 3seconds when there is no mic
signal.
8. Once the machine in trouble, please send it to distributor.
9