Installing The Device; Mounting The Device - Siemens RUGGEDCOM RS8000H Installation Manual
Hide thumbs
Also See for RUGGEDCOM RS8000H:
- Installation manual (40 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
RUGGEDCOM RS8000H
Installation Guide
Installing the Device
The following sections describe how to install the device, including mounting the device, installing/removing
modules, connecting power, and connecting the device to the network.
DANGER!
Electrocution hazard – risk of serious personal injury and/or damage to equipment. Before performing
any maintenance tasks, make sure all power to the device has been disconnected and wait
approximately two minutes for any remaining energy to dissipate.
IMPORTANT!
This product contains no user-serviceable parts. Attempted service by unauthorized personnel shall
render all warranties null and void.
Changes or modifications not expressly approved by Siemens Canada Ltd. could invalidate
specifications, test results, and agency approvals, and void the user's authority to operate the
equipment.
IMPORTANT!
This product should be installed in a restricted access location where access can only be gained by
authorized personnel who have been informed of the restrictions and any precautions that must be
taken. Access must only be possible through the use of a tool, lock and key, or other means of security,
and controlled by the authority responsible for the location.
•
Section 2.1, "Mounting the Device"
•
Section 2.2, "Connecting Power"
•
Section 2.3, "Connecting the Failsafe Alarm Relay"
•
Section 2.4, "Grounding the Device"
•
Section 2.5, "Connecting to the Device"
•
Section 2.6, "Cabling Recommendations"
Section 2.1
Mounting the Device
The RS8000H is designed for maximum mounting and display flexibility. It can be equipped with connectors that
allow it to be installed in a 48 cm (19 in) rack, 35 mm (1.4 in) DIN rail, or directly on a panel.
NOTE
For detailed dimensions of the device with either rack, DIN rail or panel hardware installed, refer to
Chapter 5, Dimension
The following sections describe the various methods of mounting the device:
•
Section 2.1.1, "Mounting the Device on a DIN Rail"
•
Section 2.1.2, "Mounting the Device to a Rack"
Mounting the Device
Drawings.
Chapter 2
Installing the Device
5
Advertisement
Table of Contents
