Attaching Cup Holder And Storage Pouch; Adjusting Handle - Century PM-1109AB Instruction Manual

3
Secure Wheel to Axle as shown:
• Push Connector onto Axle with Ribs facing in.
• Slide Wheel onto Axle and push into Connector.
• Slide Wheel Retainer onto end of Axle. Make sure large
end of Wheel Retainer is towards Wheel. Wheel Retainer
should snap into groove on end of Axle.
• Snap wheel Retainer Cap over Wheel Retainer.
• Line up Hub Cap tabs with slots in Wheel and snap Hub
Cap in place.
Hub
Cap
Wheel
Retainer
Retainer
Cap
CAUTION:
• Failure to install retainer cap may cause wheels to come
off of stroller.
• After wheel assembly is complete, pull on wheels to check
that they are locked into place.
WARNING
Prevent a possible choking hazard, discard
axle protectors and polybag which contained
rear wheel parts.
ASSEMBLY continued
Ribs
Axle
Connector
Wheel
Bracket

Attaching Cup Holder and Storage Pouch

• Snap one end of cup holder
over stroller frame above
canopy, rotate down to
opposite side and snap in
place.
• Snap both straps of storage
pouch over stroller handle
as shown.
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping. DO NOT place more
than 3 lbs. (1.4 kg) in cup holder and
storage pouch combined.
Brake
Lever

Adjusting Handle

1
Twist both handle locks inwards
until loose.
2
Grasp center of handle and pull
out to desired length.
3
Twist both handle locks outwards
until they are tight.
DO NOT over tighten handle
locks.
4