Attaching Car Seat Adapter - Century 4-in-1 system Instruction Manual

4
Slide wheel connector onto end of axle
rod with ribs and connector facing in.
5
Secure wheel to axle:
• Snap wheel retainer onto grooved end of axle. Make sure
large end of wheel retainer is towards wheel.
• Snap wheel retainer cap over wheel retainer.
• Line up hub cap tabs with slots in wheel and snap hub cap
in place.
Hub
Cap
Wheel
Retainer
Retainer
Cap
CAUTION:
- Failure to install retainer cap may cause wheels to
come off of stroller.
- After wheel assembly is complete, pull on wheels to
check that they are locked into place.
WARNING
Prevent a possible choking hazard, discard axle protectors
and polybag which contained rear wheel parts.
CAR SEAT/STROLLER ASSEMBLY continued
Connector
Wheel

Attaching Car Seat Adapter

Before using car seat/stroller, you
MUST attach car seat adapter to
stroller.
1
Set footbrakes to prevent stroller from
moving.
NOTE: It is only necessary to push
down on one brake lever. Both brakes
are locked from either side.
2
Stroller seat back MUST be in the reclined
position to use car seat adapter.
Brake
Lever
Bracket
3
Align sides of adapter brackets so
that stroller handle grip buttons are
below adapter brackets.
NOTE: Adapter release triggers
MUST face away from stroller.
4
Rotate adapter brackets into handle grip openings while
sliding catch down.
5
Release catch when in place.
Pull on adapter to be sure it is securely attached.
Bracket
Catch
Release
Trigger
Button
4