Locking Clip - Century PM-1109AB Instruction Manual

Locking Clip

WARNING
Avoid serious injury or death:
• Failure to use locking clip where
required will result in car seat not
being securely held in place.
• Remove locking clip from seat belts
when not being used with car seat.
You MUST use locking clip provided with
car seat with a vehicle seat belt that slides
freely through the latch plate or the lap belt
cannot be tightly secured.
1
Install car seat and tighten vehicle seat belt.
2
Hold seat belts together at latch plate (fig. a)
then unbuckle.
3
Slide locking clip on seat belts approximately
1/2 inch (1 cm) away from latch plate.
4
Re-buckle seat belt.
5
Test installation to see if car seat is secure. If
not secure, additional belt tightening may be
required.
Remove locking clip and repeat steps 1
through 5.
HINT: Tighten vehicle seat belt by pressing
base or car seat further down into vehicle seat
cushion.
(fig. a)
1/2 inch (1 cm)
19