Attaching Cup Holder - Century 4-in-1 TravelSolutions Instruction Manual

2
With stroller laying face down
on floor, slide Brake Housing
onto rear leg until it clicks in
place.
NOTE: Brake levers must face
rear of stroller.
Repeat for opposite leg.
3
While holding Axle Sleeve
between Brake Housings, slide
Axle through Brake Housing,
Axle Sleeve and opposite Brake
Housing.
4
Secure Wheel to Axle:
• Slide Wheel onto Axle with Ribs facing in.
• Push Wheel Retainer onto end of Axle while supporting
opposite end of Axle (to keep Axle from sliding). Wheel
Retainer will snap into groove on end of Axle.
NOTE: Make sure large end of Wheel Retainer is towards
Wheel.
• Snap Retainer Cap over Wheel Retainer.
• Line up Hub Cap tabs with slots in Wheel and snap Hub
Cap in place.
Repeat for opposite wheel.
Hub
Cap
Wheel
Retainer
Retainer
Cap
CAUTION:
• Failure to install retainer cap may cause wheels to come
off of stroller.
• After wheel assembly is complete, pull on wheels to check
that they are secure.
ASSEMBLY continued
Housing
Axle
Axle
Sleeve
Ribs
Axle
Brake
Housing
Wheel

Attaching Cup Holder

Brake
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping. DO NOT place more
than 3 lbs. (1.4 kg) in cup holder.
1
Rotate both Locking Levers to
open position as shown.
2
Snap one end of cup holder
over stroller frame above
handle locks, rotate down to
opposite side and snap in
place.
3
Rotate both Locking Levers
over handle tubes to secure
cup holder to handle.
Axle
Sleeve
Locking Levers
Locking Levers
4