Ricoh Aficio 1232C Operating Instructions Manual page 99

Problem
In Image Repeat mode, the
original image is not cop-
ied repeatedly.
The stamp position is
wrong.
When Combine, parts of
the image are not copied.
Order of copies is not cor-
rect.
When Duplex, copy is
made Top/Bottom even
though Left/Right is se-
lected.
Paper does not output dur-
ing printing with stapling.
Colours changed even
though they were not se-
lected.
Colours not selected will be
erased when using Erase
mode.
Cause
You selected copy paper
the same size as the origi-
nals, or you did not select
the proper reproduction
ratio.
The paper orientation is
wrong.
You specified a reproduc-
tion ratio that does not
match the sizes of your
originals and copy paper.
You placed the originals in
the incorrect order.
You placed the originals in
the wrong direction.
When you stop printing
while using the staple func-
tion, papers not stapled
during printing may be left
in the staple unit.
If colour range is set to
"Wider" and if red is select-
ed, colours such as magen-
ta and orange may change.
If colour range is set to
"Wider" and if red is select-
ed, colours such as magen-
ta and orange may change.
If You Cannot Make Copies as You Want
Action
Select copy paper larger than the
originals.
Select the proper reproduction ratio.
Check the paper orientation and
stamp position.
When you specify a reproduction
ratio using Manual Paper Select
mode, make sure that the ratio
matches your originals and the copy
paper.
Note
❒ Select the correct reproduction
ratio before using Combine
mode.
When placing a stack of originals in
the document feeder, the last page
should be on the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
Place the originals in the correct ori-
entation. ⇒ p.12 "Original Orienta-
tion"
Press the { { { { Reset} } } } key and cancel
copy settings, including stapling.
Adjust the colour range by setting
the colour width. ⇒ p.106 "Adjust
Colour Image"
Adjust the colour range by setting
the colour width. ⇒ p.106 "Adjust
Colour Image"
4
89