Date & Time Set Procedure; Applying The Cuff - HoMedics BPW-060-DDM Manual

DATE & TIME SET PROCEDURE
1. To adjust the date/time, press the Set button
located on the side of the monitor. The display will
show a blinking number showing the month.
2. Change the month by pressing the
Each press will increase the number by one in
a cycling manner. Press the Set button
to confirm the entry, and the screen will show
a blinking number representing the day of
the month.
3. Change the date and time as described in
Step 2 above, using the
numbers and the Set button
entries.
repeat process to set date and time

APPLYING THE CUFF

1. Remove all watches, wrist jewelry, etc. prior
to attaching the wrist monitor. Clothing
sleeves should be rolled up and the cuff
should be wrapped around bare skin for
correct measurements.
button.
again
button to change the
to confirm the
Press the button
blinking month
increasing month
confirm the entry
15
2. Apply cuff to left wrist with
palm facing up as shown
in Fig. A.
3. Make sure the edge
of the cuff is about
1/4"~1/2" (1 cm) from the
palm as shown in Fig. B.
4. In order to insure accurate
measurements, fasten the
hook and loop strap
securely around your wrist
so there is no extra space
between the cuff and the
wrist as shown in Fig. C.
If the cuff is not wrapped
tight enough, the meas-
urement values will not be
accurate.
5. If your physician has
diagnosed you with poor
circulation in your left
arm, place the cuff around
your right wrist as shown
in Fig. D.
Fig. A
Fig. B
Fig. C
Fig. D
16