Potential For Electromagnetic Interference; Troubleshooting - HoMedics BPW-060-DDM Manual

POTENTIAL FOR ELECTROMAGNETIC
INTERFERENCE
To avoid inaccurate results
caused by electromagnetic
interference between
electrical and electronic
equipments, do not use the
device near a cell phone or
microwave oven.
31

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn Batteries have
on when the run down.
START/STOP
button is pushed.
Battery polarities
have been posi-
tioned incorrectly.
EE measurement Cuff has been
error symbol shown placed incorrectly.
on display or the
blood pressure
Did you talk or
value is displayed
move during
excessively low
measurement?
(or high).
Shaking of the wrist
with the cuff on.
E1 error symbol Air circuit
shown on display abnormality.
E2 error symbol Inflation pressure
shown on display exceeding 300 mmHg.
E3 error symbol Error determining
shown on display measurement data.
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassem-
ble or attempt to repair the unit by yourself. Contact infor-
mation for HoMedics Consumer Relations Department can
be found on the warranty page (See page 34).
32
CORRECTION
Replace them
with two new AAA
alkaline batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff prop-
erly so that it is
positioned correctly.
Measure again.
Keep wrist
steady during
measurement.
Measure again.
Switch the unit off,
then measure again.
Measure again.