Viewing the Current Date and Time
The master users can view the system time and date setting on an alpha keypad.
Other users can view the time/date if a function key has been programmed to do so.
(Master Code)
OR,
Press the function key (A, B, C, or D) for viewing current
date and time, if programmed.
A typical time/date display is shown.
The display will remain on for about 30 seconds or until a
key is pressed.
" A"
If one of the above keys has been programmed for the date/time display feature, place
a check mark in the box beneath that key.
Setting the Date and Time
NOTE: All partitions must be disarmed before date/time can be set.
You can set the time and date by doing the following:
1.
(Master Code)
2. Press [∗] when the time/date is displayed.
A cursor appears under the first digit of the hour.
To move cursor ahead, press [
• Enter the 2-digit hour setting.
• Enter the 2-digit minute setting.
• Press [1] for PM or [2] for AM.
• Enter the last two digits of the current year.
• Enter the 2-digit month setting.
• Enter the 2-digit day setting.
3. To exit, press [∗] when cursor is at the last digit, or wait
30 seconds.
+ [#] + [6] [3]
" B "
" C"
" D"
+[#] + [6] [3]
∗
]. To go back, press [#].
Date and Time
Alpha Display:
Alpha Display:
Current time display
Time/date editing display
-21-
∗∗∗∗DISARMED∗∗∗∗
READY TO ARM
TIME/DATE
SAT
12:05AM_05/09/00
∗∗∗∗DISARMED∗∗∗∗
READY TO ARM
TIME/DATE
SAT
04:04PM 10/17/00
TIME/DATE
SAT
04:04P2000/10/17