Cleaning And Maintenance; Washing Instructions - BQS BT012 Instructions For Use Manual

5. INSTALLING CHILD SEAT. GROUP 2.
WARNING
Before installing the seat for Group 2, the seat,
protectors, H buckle and L harness adjustment button must be
removed (5.1).
1. Put the seat in position 4 (5.1).
2. Release connectors O and
belts thereof. (5.2, 5.3 and 5.4).
3. From the front pull the harness straps towards you to get them out of
the shoulder holes, separate the belt harness protectors (5.5).
4. From the underside of the seat insert part
the buckle to remove the entire base (5.6, 5.7 and 5.8).
5. From the underside of the seat pull connectors
the harness tapes from the base of the seat (5.6 and 5.9).
6. Lift the cover of the base of the seat, and with a screwdriver remove
the screw and remove the harness adjustment part (5.10), removing
the seat belt, remove connector
of the harness adjustment tape (5.2).
7. Place the child seat on the vehicle seat, ensuring it is pressed firmly
against the back of the vehicle seat (5.11).
8. Place the child in the child restraint seat (5.12).
9. Move the vehicle safety seat belt through the
vertical guides; make sure the belt is not twisted (5:13).
10. Insert the seat belt in the vehicle anchor point and press until you hear
a "click" so that the child seat is properly installed (5.14).
11. Make sure the vehicle's safety belt is not twisted, also check that the
seat cover does not impede the movement of the vehicle safety seat
belt or prevent the installation of the seat in any way. To release the
child unbuckle the vehicle safety belt as described in the instructions.
IMPORTANT
Ensure that the belt has no slack.
Child restraint system
26
Only suitable for Group 2, approx.
4 to 6 years (15-25 Kg.)
G harnesses, C
Q on the back of the seat and remove the
1 insert in the hole and pull
2 outwards to remove
Q from behind the seat with the rest
F waist guides and

6. CLEANING AND MAINTENANCE.

Removing
1. The cover of the safety seat must be removed for washing, first
loosen the metal connector harness straps
harness
from the front of the seat pull the harness straps towards you
removing them from the seat grooves (6.3 and 6.4).
2. Unbutton the push buttons that are on both sides of the child safety
seat (6.5).
3. Carefully remove the seat cover (6.6).
Cleaning the seat
1. Wash the straps and plastic parts with neutral detergent and warm
water.
2. Ensure that no soap enters the buckle or metal parts.
3. Do not use chemicals or bleach on any part of the chair.
4. Dry thoroughly before use.
B
If you have any question about using or installing this product, or if you
need a spare part contact our Customer Service.
BT012 Group 0+/1/2
O (6.1 and 6.2). Then

WASHING INSTRUCTIONS:

· The cover is removable and washable at
30º. Dry in the fresh air only.
· Wash in washing machine (cold).
· Do not use bleach.
· Dry clean, with any solvent except
trichloroethylene.
· Do not use dryer.
· Do not iron.
www.babyqs.com
EN
27