Table of Contents
Advertisement
Problem
The display shows an error
code that is not in this table.
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows "Demo".
The descaling procedure is
interrupted before it finishes.
The descaling procedure is
interrupted before it finishes.
There is no water inside the
grill- / roasting pan after the
descaling procedure.
There is dirty water on the
bottom of the cavity after
the descaling cycle.
The cleaning function is in-
terrupted before it finishes.
The cleaning function is in-
terrupted before it finishes.
There is too much water on
the bottom of the cavity af-
ter the end of the cleaning
function.
There is no good perform-
ance of the cleaning proce-
dure.
Possible cause
There is an electrical fault.
You left the dish in the oven
for too long.
The demo mode is activa-
ted.
There was a power cut.
The function was stopped by
the user.
You did not fill the water
drawer to the maximum lev-
el.
The grill- / roasting pan is on
a wrong shelf position.
There was a power cut.
The function was stopped by
the user.
You sprayed too much de-
tergent in the appliance be-
fore the activation of the
cleaning cycle.
The initial oven cavity tem-
perature of the steam clean-
ing function was too high.
ENGLISH
Remedy
• Deactivate the oven with
the house fuse or the
safety switch in the fuse
box and activate it again.
• If the display shows the
error code again, contact
the Customer Care De-
partment.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Basic Settings" in
"Daily use" chapter.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling
agent / water is present in
the water drawer body.
Repeat the procedure.
Remove the residual water
and the descaling agent
from the bottom of the
oven. Put the grill- / roasting
pan on the first shelf posi-
tion.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity
with a thin layer of the deter-
gent. Spray the detergent
evenly.
Repeat the cycle. Run the cy-
cle when the appliance is
cold.
49
Advertisement
Table of Contents
