Maintenance Schedule; Putting Out Of Service - Whisper Power W-SQ16 User Manual

MAINTENANCE
4.3.1

Maintenance schedule

Check oil level
Check the level of the cooling liquid
Change oil and oil filter
Check and tighten nuts, bolts, etc.
Check exhaust
Check and readjust V-belt
Check electrical connections
Change oil
Check battery
Check and readjust V-belt
Check impeller water pump
Replace oil filter
Replace fuel filter
Replace impeller coolant pump
Check the air strainer element
Check the air filter element
Replace the V-belt
Retighten cylinderhead bolts and readjust
valve clearance
Check and clean radiators
Replace or clean the air strainer element
Check lubricating oil pressure
Check injector and injection pressure
Replace or clean the air filter element
24
daily
daily
after first 50 hours
after first 50 hours
after first 50 hours
after first 50 hours
after first 50 hours
150 hours
150 hours
150 hours
300 hours
300 hours
300 hours
500 hours
500 hours
500 hours
1000 hours
1000 hours
1000 hours
2000 hours
2000 hours
2000 hours
2000 hours
4.3.2

Putting out of service

When not using the generating set for a longer period it is
recommended to execute
procedure.
1 Clean the engine.
2 Loosen the fuel suction pipe and fuel return and put
them in a can with preservation diesel fuel. Start the
engine and run the engine warm.
3 Drain the hot engine oil and refill with preservation oil.
4 Stop the engine.
5 The coolant can stay in the engine
6 Disconnect the battery and store it in a place free of
frost and dry and charge it regularly.
7 Close inlet- and outlet openings with tape.
8 Protect the generating set against the influences of
bad weather conditions.
This method of preservation will be sufficient for 6 months.
Repeat steps 2, 3, and 4, every 6 months. Change oil
before using the engine again.
January 2009 / W-SQ16 for mobile applications / EN
an engine preservation