Table of Contents
Advertisement
Universal Serial Bus Connectors
USB 3
USB 2
USB 1
USB 0
2
1
The system board supports 8 USB 2.0/1.1 ports. USB allows data
exchange between your computer and a wide range of simultane-
ously accessible external Plug and Play peripherals.
Four onboard USB 2.0/1.1 ports (Black) are at locations CN7 (USB
2-3) and CN8 (USB 0-1) of the system board.
The J10 (USB 4-5) and J11 (USB 6-7) connectors allow you to
connect 4 additional USB 2.0/1.1 ports. The additional USB ports
may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then
insert the connector that is attached to the USB port cables to J10
and/or J11.
BIOS Setting
Configure the onboard USB in the Integrated Peripherals submenu
("Onboard Device" section) of the BIOS. Refer to chapter 3 for
more information.
1 0
9
Hardware Installation
2
USB 4-5
USB 6-7
39
Advertisement
Table of Contents
