DFI G7S600-B User Manual page 13

The system board is equipped with an IrDA connec-
irda
tor for wireless connectivity between your computer
and peripheral devices. The IRDA (Infrared Data Association) specifi-
cation supports data transfers of 115K baud at a distance of 1
meter.
The system board supports USB 2.0 and USB 1.1
USB
ports. USB 1.1 supports 12Mb/second bandwidth
while USB 2.0 suppor ts 480Mb/second bandwidth providing a
marked improvement in device transfer speeds between your com-
puter and a wide range of simultaneously accessible external Plug
and Play peripherals.
wake-on-ring
wake-up/power-on to respond to calls coming from an external mo-
dem or respond to calls from a modem PCI card that uses the PCI
PME (Power Management Event) signal to remotely wake up the
PC.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-lan
It is supported via the onboard LAN port, via a PCI LAN card that
uses the PCI PME (Power Management Event) signal or via a LAN
card that uses the Wake-On-LAN connector. However, if your sys-
tem is in the Suspend mode, you can power-on the system only
through an IRQ or DMA interrupt.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-PS/2
tem.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
This feature allows the system that is in the
Suspend mode or Soft Power Off mode to
This feature allows the network to remotely
wake up a Soft Power Down (Soft-Off) PC.
This function allows you to use the PS/2 key-
board or PS/2 mouse to power-on the sys-
Introduction
1
13