Setting The Remote Control Id Numbers - Panasonic PT-DZ780 Operating Instructions Manual

Chapter 3 Basic Operations — Operating with the remote control

Setting the remote control ID numbers

When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using single remote control, if a unique ID number is assigned to each projector.
After setting the ID number of the projector, set same ID number on the remote control.
The factory default ID number of the projector is set to [ALL]. When using a single projector, keep
pressing the <ID SET> button on the remote control for at least three seconds to set the ID number of
the remote control to [ALL]. In addition, when the ID number of the projector is unknown, setting the ID
number to [ALL] enables the remote control.
button
1) Press the <ID SET> button on the remote control.
2) Within five seconds, press and set the one-digit or two-digit ID number set on the projector using the
number (<0> - <9>) buttons.
f When the ID number is set to [ALL], you can control the projector regardless of the ID number setting of the
projector.
Attention
f Since the ID number of the remote control can be set without the projector, do not press the <ID SET> button on the remote control
carelessly. If the <ID SET> button is pressed and no number (<0> - <9>) buttons are pressed within five seconds, the ID number returns to
its original value before the <ID SET> button was pressed.
f The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control is left with dead
batteries. Set the same ID number again when the batteries are replaced.
Note
f When the ID number of the remote control is set to [0], you can control the projector regardless of the ID number setting of the projector, as
same as when [ALL] is set.
f Set the ID number of the projector from the [PROJECTOR SETUP] menu → [PROJECTOR ID].
ENGLISH - 69