Panasonic PT-DZ780 Operating Instructions Manual page 121

3) Press asqw to select an item.
f The items will switch each time you press the button.
[LAST USED]
[RGB1]
[RGB2]
[DVI-D]
[HDMI]
[DIGITAL LINK]
[SDI]
*1
[INPUT1] - [INPUT10]
*1 Only for PT-DZ780
*2 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. If an item where the input name is not reflected is selected, it is disabled.
Note
f When [BACKUP INPUT MODE] in the [DISPLAY OPTION] menu → [BACKUP INPUT SETTING] (x page 97) has been set to [ON],
and the projector has been turned off with the input set to HDMI, projection will start with the DVI-D input, even when [STARTUP INPUT
SELECT] is set to [LAST USED].
[RS-232C]
Set the communication conditions of the <SERIAL IN>/<SERIAL OUT> terminals. Refer to "<SERIAL
IN>/<SERIAL OUT> terminal" (x page 180).
Setting the communication condition of the <SERIAL IN> terminal
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [INPUT SELECT].
4) Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
5) Press as to select [(IN) BAUDRATE].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
7) Press as to select [(IN) PARITY].
8) Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Setting the communication condition of the <SERIAL OUT> terminal
1) Press as to select [RS-232C].
Chapter 4 Settings — [PROJECTOR SETUP] menu
Keeps the input selected last.
Sets the input to RGB1.
Sets the input to RGB2.
Sets the input to DVI-D.
Sets the input to HDMI.
Sets the input to DIGITAL LINK.
Sets the input to SDI.
Sets the input to DIGITAL LINK, and switches the input of Panasonic twisted-pair-cable transmitter to
*2
the specified input.
Use the <SERIAL IN> terminal of the projector to perform RS-232C communication.
Performs RS-232C communication via the DIGITAL LINK output supported device (Model No.:
ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
Select the proper speed.
Select the parity condition.
ENGLISH - 121