Additional Support; Warranty - Philips 6917348PH User Manual

remote is connected to. In order to copy the
remote, repeat the procedure described in point
b.
Once you have connected one or more lamps to your
Philips LivingColors remote control, you can control
all of these lamps together or each one individually.
To control a single lamp, you need to select it (please
note that for LivingColors coloured and white
light, coloured and white light need to be selected
separately). You can do this using one of the light
selection buttons. When you press and hold one of
the light selection buttons, the selected lamp will start
blinking. If this is not the lamp you would like to
adjust, release the button and press it again; another
lamp will start blinking. When a lamp is selected, the
light selection indicator on the remote control (light
bulb) will light up. This means you can now adjust the
selected lamp only.
When no light is selected (light selection indicator is off),
all your adjustments will apply to all lights connected
to the remote control (for example, you can dim all
lights in the room).
If you like a particular combination of light settings of
different luminaires, you can also store it as a scene in
the same way as described in section 2 of this manual.
4. Frequently asked questions
What to do if...
o The LivingColors is not providing light
o Check the connections of the cord to the
lamp. Check that the plug is correctly placed
in the wall socket.
o Remove the power cord and put it back. If the
LivingColors changes several colours and then
goes off, use the remote control to switch it
back on.
o The LivingColors is not responding to the
remote control
o Check the batteries in the remote control.
The batteries should be correctly inserted (+
and -) and should be charged. If the remote
control is still not working, try replacing the
batteries.
o Link the remote to the LivingColors by
following the procedure described in section
3.1 of this manual.
o Buttons are flashing after I have used the
remote control
o This means that the batteries in the remote
control are (almost) empty and need to be
replaced.
I cannot start the automatic colour-
o
changing mode
o It could be that the remote control did not
understand your "sweep" movement. Please
try again, making sure that your finger is
on the colour wheel during the full circle
movement
o I would like to connect the LivingColors
to a timer. Is this possible?
o Yes. You can use Philips LivingColors with a
timer (not included). When switched on with
a timer, the LivingColors will show your last
setting (static colour or automatic colour-
changing mode). Please make sure that your
last setting is not "off".
o I cannot connect additional lamps to the
LivingColors remote control
o Please make sure that the product you are
trying to connect has a SmartLink logo on it.
Only products with a SmartLink logo can be
connected to this remote control.
o Try repeating the procedure described in
section 3 of this manual. Make sure you
do hear the sounds and see the flashes as
described there.
o My question is not listed here
o Please contact Philips for assistance (see
section 5 "Additional support").
5.

Additional support

For information and in the event of any problem,
please visit the Philips website at
or contact the Philips Lighting Contact Centre free
of charge in the U.S.: 00800-PHILIPSL or 00800-
74454775

Warranty:

The Philips two-year warranty is valid if the product
is used in accordance with the instructions and for
its intended purpose. Claims will only be accepted on
submission of the original proof of purchase (invoice,
sales slip or receipt) stating the purchase date, the
name of the dealer and a description of the product.
The Philips warranty lapses if:
- Anything has been changed, crossed out, deleted
or rendered illegible on the purchase docket or
product description.
- The failure is caused by damage, faulty connections
or abuse.
21
www.philips.com