Firmtech FB100AS-F User Manual page 29

FB100AS-F User Guide
12.2.2 How to Use PC Configuration Menu
The user may select the menu to change by selecting the given number in front of the left end menu.
For example : To change "DEVICE NAME", enter : [1][Enter]
Note :
When Reset Button is pressed at <Figure 12-11>, all the set up value shall be reset to the initial
set up status (factory fix point).
Following is the order to use the menu.
(1) The execution will only be executed by pressing the "Enter" key.
(2) The small character "t" will always move to be positioned at upper side of the menu.
(3) To move menu, use the number in the end of left side.
completion of input.
(4) "←" key is used to delete the entered character currently.
(5) If the entered character is unreadable or is not supported at the appropriate menu, "Retry >"
message will be output.
(6) If the input message is more than 12 characters, "Overflow buffer" message will be output and then
"Retry >" message appeared as well.
Upon completion of PC Configuration setting up, turn off the FB100AS-F, and change the Function Dip
Switch #4 (PC configuration) to OFF position and turn the power ON, which will start the Bluetooth to
operate normally.
Note :
Please refer to the Appendix A, details of PC Configuration for detailed value description of PC
Configuration.
Version 1.0 How to complete PC Configuration?
12
Please be sure to "Enter" key upon
Page 29 / 30