Table of Contents
Advertisement
4.
SAFE LOADING AND TRANSPORT OF
THE EXCAVATOR
1. Observe all regulations concerning the transport of
excavators on public roads.
2. Use adequately long and robust ramps when loading
on the machine. (for details see "TRANSPORTING
THE EXCAVATOR ON A VEHICLE")
3. Do not change the running direction and to avoid
tipping over, do not try to swing the attachment
crosswise to the loading ramps.
4. Lower the attachment on the loading bed and release
the pressure from the hydraulic system.
After loading the excavator on the truck, block the
tracks with blocks and tie down the excavator at the
appropriate locations.
(1) Chain
(2) Block
5. Avoid abrupt braking of the vehicle with the excavator
loaded. Sudden braking causes the excavator to move
and may cause a serious accident.
6. Do not use the hooks on the roof of CAB for lifting the
excavator.
5.
MAINTENANCE
Before doing maintenance work on the excavator, place
the machine on a firm, flat and level surface, lower the
attachments to the ground, stop the engine, release
pressure trapped in the hydraulic system, lock all control
levers and remove the key. When dismantling hydraulic
parts, make sure that the hydraulic oil has cooled down
sufficiently to avoid burns.
Start maintenance work carefully, e.g. loosen plug slowly
so that oil will not squirt out.
1. Before doing work on the engine, the exhaust system,
the radiator and the hydraulics, let the excavator cool
down sufficiently.
2. Always turn off the engine when filling the fuel tank.
Avoid spilling and over-filling of fuel.
3. Smoking is prohibited while refueling or handling the
battery. Keep sparks and fire away from the fuel tank
and battery. Flammable gases escape from the
battery, especially during charging.
4. Do not use or charge a refillable type battery if the fluid
level is below the LOWER (lower limit level) mark.
Otherwise,
the
battery
prematurely deteriorate, which may shorten the
battery's service life or cause an explosion. Check the
fluid level regularly and add distilled water as required
so that the fluid level is between the UPPER and
LOWER levels.
5. Read and follow the directions "STARTING WITH AN
AUXILIARY BATTERY" in "OPERATION OF THE
ENGINE", when starting with an auxiliary battery.
6. Keep a first-aid box and a fire extinguisher at hand at
all times.
7. Do not open the radiator cap before the radiator has
cooled down sufficiently.
First loosen the cap to the first stop and allow the
system enough time to release the remaining
pressure. Then loosen the cap completely.
8. To avoid short-circuiting the battery, always remove
the ground cable first and attach the positive cable
first.
SAFE OPERATION
component
parts
5
-
may
Advertisement
Table of Contents
