SMC Networks FieldServer FS-8700-130 Driver Manual page 23

Table of Contents

Advertisement

Error
#1 FYI. Incoming data
is being abandoned on
Port<%d>
Node<%u>
Loop<%d>
Data_Type<%s>
Address<%d>
#2 Err. Reset/Normal
queue<%d>
full
on
MD<%s>
#3 FYI. Event<%s> not
Supported.
#4 Err. Unknown Node
Trouble <%s>
#5 Err. Unknown OFF
NETWORK Node <%s>
#6
Err.
Unsupported
Point
Address
Format<%s>
#7
FYI.
Attempt
to
decrement below zero
offset<%d> DA<%s>
3
All Data Arrays on the FieldServer are initialized to zero on rebooting or starting up. A zero value in the Data Array assumes no
problems with the devices, but if a problem existed before the startup and the device comes out of problem, the FieldServer will
attempt to decrease the number of problems by 1 and this generates the error. Data from the FieldServer should not be considered
reliable until the "System Normal" message has been returned.
Description
The FieldServer got a recognized
message on this particular port,
Node, loop, Address_Type and
Address but did not find a defined
Map Descriptor.
This driver keeps track of all non-
zero memory locations per Map
Descriptor. When the track queue
is
full,
the
oldest
overwritten with the latest one.
This could be a problem
System_Reset and System_Normal
where
memory
locations
cleared as per this queue.
The
FieldServer
received
unrecognized event or corrupted
message.
The FieldServer received a Node
Trouble event not listed under
Appendix
A.2
or
a
message.
The
FieldServer
received
message
that
a
Node
connected or disconnected from
the network, but no Node number
was received - it is likely that the
message was corrupted
A message was received from an
unsupported device or the address
of the device is not in the correct
format/location.
The driver attempted to decrement
the trouble counting number to a
number less than 0.
Page 23 of 23
FS-8700-130 Notifier NCA2-NFS2-3030 Manual
Action
To capture this data, add a new Map
Descriptor
parameters.
If the error occurs during installation or
testing, it can be ignored. If the error
offset
is
occurs during field operation, configure
the
Map
on
address ranges only and keep the Map
Descriptor length smaller than the
get
queue length.
an
If the error occurs continuously, check
that connection parameters match with
panel port settings.
If this error occurs continuously and
you need this new trouble status,
corrupted
contact FieldServer.
a
either
Call Tech support.
Call Tech support.
This
occurs
synchronization
FieldServer and the Notifier panel or
because a problem existed before
connection.
"System Normal" message. Check the
configuration file to identify the address
and memory area type mapped to this
offset and the Data Array which is
causing the error.
with
the
required
Descriptor
with
required
due
to
between
3
. It will rectify itself upon
poor
the

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FieldServer FS-8700-130 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents