Rc (Remote Controller) Setup Menu; All Clear - Furuno NAVpilot 711 Installation Manual

3.17 RC (Remote Controller) SETUP Menu

Note: The [RC SETUP] menu is not shown in case of Fantum Feedback
Set the type of remote controller you have as follows
1. The setting for [REMOTE CONTROLLER 1] is selected; push the knob.
2. Rotate the knob to select the type of remote controller connected.
[NFU]: Select for lever-type remote controller.
[FU]: Select for dial-type remote controller.
[DODGE]: Select for dodge-type remote controller.
[DISABLE]: Disable remote controller operation.
3. Set the type for remote controller 2, if connected.

3.18 All Clear

The all clear feature restores all default settings.
1. Push the knob three times while pressing the [MENU] key in the STBY mode.
The [INSTALLATION] menu appears.
2. Select [SYSTEM SETUP].
3. Select [ALL CLEAR] and [YES] to restore all default settings.
RC SETUP
REMOTE CONTROLLER1:
REMOTE CONTROLLER2:
3. INITIAL SETTINGS
DISABLE
DISABLE
TM
.
NFU
FU
DODGE
DISABLE
3-39