Related Manuals for Pakedge Device & Software SE-8P
Summary of Contents for Pakedge Device & Software SE-8P
- Page 1 SE-8P 8 Port Gigabit Unmanaged Switch with 8 ports PoE or 4 ports PoE+ User Manual Version 1.0...
- Page 2 FCC Certifications This Equipment has been tested and found to comply with the limits for a Class digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
-
Page 3: Unpacking Information
The store-and-forward architecture filters errors and forwards packets in a non-blocking environment. Flow control ensures the accuracy of the data transmitted. The PoE+ on the SE-8P supplies power for connected devices that need it. Over current protection and circuit shorting protection are also supported. -
Page 4: The Front Panel
128K bytes buffer memory Supports automatic loop detection and isolation Supports 9K bytes Jumbo Frames Supports extensive LED indicators for network diagnostics Internal power adapter FCC, CE and LVD The Front Panel The front panel consists of LED indicators. For detailed LED definition, please refer to the next paragraph. -
Page 5: Power Receptacle
Power Receptacle To be compatible with the varying electric service standards around the world, the switch comes with a power supply which can operate from 100 to 240VAC, 50/60Hz. Please make sure that your outlet standard is within this range. To power on the switch, plug the female end of the power cord firmly into the receptacle of the switch and the other end into an electric service outlet. -
Page 6: Rack Mount Installation
Rack-mount Installation Rack mounting facilitates an orderly installation when a series of networking devices are installed. The switch is supplied with rack mounting brackets and screws Procedures to Rack-Mount the Switch: 1. Disconnect all the cables from the switch before continuing. 2. -
Page 7: Product Specifications
Product Specifications IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX Standard IEEE802.3x full-duplex flow control IEEE802.3ab 1000BASE-T IEEE 802.3af/at PoE standard (DTE power via MDI) 8*10/100/1000 Mbps auto MDI/MDI-X RJ-45 switching ports Supports 136W Max; Interface Full load: 31.5W(at) x 4 Ports 15.4W(af) x 8 Ports Cable RJ-45 (10BASE-T): Category 3,4,5 UTP/STP RJ-45 (100BASE-TX): Category 5 UTP/STP... -
Page 8: Technical Support
Technical Support Please visit our website for up-to-date support information: Website: www.pakedge.com Email: support@pakedge.com CONTACT INFORMATION: Pakedge Device & Software Inc. 3847 Breakwater Avenue Hayward, CA 94545-3606 877-274-6100 © Pakedge Device & Software Inc. 2015 – All Rights Reserved...