Related Manuals for Pakedge Device & Software SE-USB1-EP
Summary of Contents for Pakedge Device & Software SE-USB1-EP
- Page 1 QUICK START GUIDE SE-USB1-EP In-Wall 2-Port Unmanaged Switch with 1-Port PD (at), 1-Port PSE (af) and 1-Port USB charger...
- Page 2 • Complies with 100BASE-TX specifications of the IEEE 802.3u standard • Complies with 1000BASE-T The SE-USB1-EP is an in-wall solution to specifications of the IEEE 802.3ab extend the existing PoE network in the standard home or office. The product is powered •...
- Page 3 Blinking: Valid port connection and data is transmitting/receiving. Off: Port disconnected. 1G LED Steady: Connection speed is 1000 Mbps. Off: Connection speed is 10/100 Mbps. Note: The unlabeled LED on the PoE Out port is unused. SE-USB1-EP Quick Start Guide...
- Page 4 2. INSERT THE ETHERNET CABLE CONNECTOR TO THE PD PORT PROPERLY appropriate cables corresponding 3. INSTALL SE-USB1-EP TO ELECTRICAL BOX 3. INSTALL SE-USB1-EP TO ELECTRICAL BOX to different transmitting/receiving speed is required. To choose a suitable cable, please refer to the 4.
- Page 5 PoE out port: Link/ACT Memory 2K MAC address table 9 KB jumbo packet length 128 KB buffer memory CE/FCC Class B Operating 0°C ~ 40°C (32° ~ 104°F) temperature Operating 10% - 90% humidity (non-condensing) SE-USB1-EP Quick Start Guide...
- Page 6 SE-USB1-EP Quick Start Guide...
- Page 7 Visit our website for up-to-date support information: Website: www.pakedge.com Email: support@pakedge.com sales@pakedge.com For regulatory information, visit pakedge.com/regulatory/ Contact information 3847 Breakwater Avenue Hayward, CA 94545-3606 U.S.A. Main: 650-385-8700 Fax: 650-685-5520 © 2016 Pakedge Device & Software Inc. All rights reserved. DOC-00225-B 2016-05-27 MS...
Need help?
Do you have a question about the SE-USB1-EP and is the answer not in the manual?
Questions and answers