Advertisement
Table of Contents
- 1 User Manual
- 2 Unpacking Information
- 3 General Description
- 4 Key Features
- 5 The Front Panel
- 6 Leds Definition
- 7 Power Receptacle
- 8 Rear Panel
- 9 Desktop Installation
- 10 Rack Mount Installation
- 11 Network Cables Installation
- 12 Port Operation
- 13 Product Specifications
- 14 Technical Support
- Download this manual
Advertisement
Table of Contents
Related Manuals for Pakedge Device & Software SE-8P4
Summary of Contents for Pakedge Device & Software SE-8P4
-
Page 1: User Manual
SE-8P4 8 Port Gigabit Unmanaged Switch with 4 Ports PoE or 2 Ports PoE+ User Manual Version 1.0... - Page 2 FCC Certifications This Equipment has been tested and found to comply with the limits for a Class digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.
-
Page 3: Unpacking Information
Unpacking Information Thank you for purchasing the Pakedge Device & Software SE-8P4 gigabit switch. Before installation, please verify that your package contains the following items. One 8-Port Gigabit Ethernet with 2-Port PoE+/4-Port PoE Switch One AC power cord Rubber feet and screws... -
Page 4: The Front Panel
ports(IEEE802.3/ 802.3u/ 802.3ab) Supports MDI/MDI-X auto crossover Supports 63W Max; Full load: 31.5W(at) x 2P = 63W 15.4W(af) x 4P = 61.6W Wire-speed packet filtering and forwarding rate Store-and-forward architecture filters fragment & CRC error packets ... -
Page 5: Power Receptacle
Power Receptacle To be compatible with the varying electric service standards around the world, the switch comes with a power supply which can operate from 100 to 240VAC, 50/60Hz. Please make sure that your outlet standard is within this range. To power on the switch, plug the female end of the power cord firmly into the receptacle of the switch and the other end into an electric service outlet. -
Page 6: Rack Mount Installation
Rack-mount Installation Rack mounting facilitates an orderly installation when a series of networking devices are installed. The switch is supplied with rack mounting brackets and screws Procedures to Rack-Mount the Switch: 1. Disconnect all the cables from the switch before continuing. 2. -
Page 7: Product Specifications
Product Specifications IEEE802.3 10BASE-T IEEE802.3u 100BASE-TX Standard IEEE802.3x full-duplex flow control IEEE802.3ab 1000BASE-T IEEE 802.3af/at PoE standard (DTE power via MDI) 8*10/100/1000 Mbps auto MDI/MDI-X RJ-45 switching ports Supports 63W Max; Interface Full load: 31.5W(at) x 2 Ports 15.4W(af) x 4 Ports RJ-45 (10BASE-T): Category 3,4,5 UTP/STP Cable Connections RJ-45 (100BASE-TX): Category 5 UTP/STP... -
Page 8: Technical Support
Technical Support Please visit our website for up-to-date support information: Website: www.pakedge.com Email: support@pakedge.com CONTACT INFORMATION: Pakedge Device & Software Inc. 3847 Breakwater Avenue Hayward, CA 94545-3606 877-274-6100 © Pakedge Device & Software Inc. 2015 – All Rights Reserved...