Table of Contents
Advertisement
NOTE
•
After connecting the water hose to the adaptor, check if it is connected properly by
pulling the water hose downwards.
•
Use a standard type of water tap. If the tap is square-shaped or too big, remove the
spacer ring before inserting the tap into the adaptor.
STEP 4 Position the drain hose
WA8700K(HEATER)_DC68-03520W-02_EN.indd 17
For models with an additional hot water
inlet:
1. Connect the red end of the hot water
hose to the hot water inlet on the back
of the machine.
2. Connect the other end of the hot water
hose to the hot water tap.
General type
1. Press and hold down the joint ring, and
insert it into the drain hose.
2. Insert the drain hose into the drain
outlet. Make sure to connect them firmly
using the joint ring.
The drain hose is extensible. Adjust the
length of the drain hose as needed.
English 17
2018-05-15
5:43:36
Advertisement
Table of Contents
