Table of Contents
Advertisement
Step-by-step installation
STEP 1 Select a location
Location requirements:
Solid, level surface without carpeting or flooring that may obstruct ventilation
•
Away from direct sunlight
•
•
Adequate room for ventilation and wiring
•
The ambient temperature is always higher than the freezing point (0 ˚C)
•
Away from a heat source
STEP 2 Leveling your washer
WA8700K(HEATER)_DC68-03520W-02_EN.indd 13
A
See if the washer is level by checking the
position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour
the water into the tub to just below the
pulsator level.
3. If the washer is level, the pulsator (A) is
positioned at the center of the water as
shown in the figure.
English 13
2018-05-15
5:43:35
Advertisement
Table of Contents
