Owner Unit Power Supply - Motorola SCOUT2300 User Manual

2.3

Owner Unit Power Supply

IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event of a
power failure.
1. Connect the small plug of the power adapter to the owner unit and the
other end to the electrical outlet. Only use the enclosed power adapter (6V
DC/500mA).
2. Press and hold the
the owner unit.
3. Once the pet and owner units are switched on, the display on the owner
unit will show the video captured by the pet unit.
4. If there is no connection or you are out of range, the video display will go
off and the words
will beep every 5 seconds. Move the owner unit closer to the pet unit until
the link is re-established.
5. Press and hold the
finishes scrolling, to turn OFF the owner unit.
NOTE
The battery icon
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 16 hours to charge fully.
When charging
1. If the owner unit is turned OFF, when the adapter is plugged in, a power
plug logo will display briefly, followed by a large battery icon with internal
segments cycling for 45 seconds. The Blue LED in the top left corner lights
up to indicate the adapter is plugged in.
Getting Started
P
POWER ON/OFF button for 1 second to turn ON
No Signal
will be shown on the LCD display, and the unit
P
POWER ON/OFF button, until the progress bar
turns RED to indicate that the battery is low, and it gives
9