Table of Contents
Advertisement
4.6.3
Delete a camera
M
1. Press the
Menu button and the menu bar will pop up.
<
2. Press the
LEFT button or
the
/
/
+
3. Press the
UP button or
button to confirm.
4.
1 /
2 /
to select the desired CAM, and press the OK button to select.
+
5. Press the
UP or
the OK button to delete that registration.
4.6.4
Scan the cameras
M
1. Press the
Menu button and the menu bar will pop up.
<
2. Press the
LEFT button or
the
/
/
+
3. Press the
UP button or
button to confirm.
4. The screen will then display images from each registered camera in a loop,
changing about every 12 seconds.
TIP
Press OK repeatedly for a quick way to go to Scan mode without using the menu.
NOTE
If the owner unit is in scan mode and one of the registered cameras
is turned off or out of range, the scan will stop at the missing camera, display "no
signal - check or del cam 1" (if camera 1 is missing), and emit a a warning beep
every 5 seconds.
WARNING
Check the camera and correct the fault immediately if you are using that
camera to monitor your pet.
If you want to continue in camera scan mode without that camera, delete the
camera (see 4.6.3 Delete a camera) and start the scan again.
4.7
Temperature
M
1. Press the
Menu button and the menu bar will pop up.
<
2. Press the
LEFT button or
+
3. Press the
UP button or
Owner Unit Menu Options
>
RIGHT button until
/
menu will pop up.
-
DOWN button to select
3 /
4 will pop up, press the
-
DOWN button to select the desired CAM, and press
>
RIGHT button until
/
menu will pop up.
-
DOWN button to select
>
RIGHT button until
-
DOWN button to select °C or °F.
is highlighted, and
, and press the OK
+
-
UP button or
is highlighted, and
, and press the OK
is highlighted.
DOWN button
15
Advertisement
Table of Contents
