Table Of Contents; Installation In The Baby's Room - Angelcare Platinum AC1100T Manual

Table of content
Installation in the Baby's room...............................................................................................................................................................................................3
Nursery Unit set up ...............................................................................................................................................................................................................4
Parents Unit set up ................................................................................................................................................................................................................4
Testing our Angelcare® monitor............................................................................................................................................................................................4
Parents Unit settings .............................................................................................................................................................................................................5
Troubleshooting.....................................................................................................................................................................................................................8
Warranty ..............................................................................................................................................................................................................................9
Maintenance of your Angelcare® monitor .............................................................................................................................................................................9
Factory settings and technical specifications .........................................................................................................................................................................9
Rechargeable Parents
Nursery Unit
Unit and charger
STEP 1 - Installation in the Baby's room
• Position the Nursery Unit facing
the crib.
• Adjust camera angle with
rotating dial.
•The Sensor Pad must rest on a completely flat and rigid surface. Place a 6mm (1/4'') thick Masonite board to cover the full size of the crib or with minimum dimensions of
28cm (11'') X 28cm (11'') X 6mm (1/4'') between the crib base and mattress,when using one Sensor Pad. The board will push the Sensor Pad into the mattress and keep
the contact between the Sensor Pad and the mattress, should the baby move around. Make sure the Sensor Pad's cord passes underneath the mattress as shown.
• Position the Sensor Pad as shown, in the center of the crib. Make sure the printed Angelcare logo faces up. Do not place any bedding between the mattress and the Sensor Pad.
• Secure the Sensor Pad cord to the crib using a tie wrap. Run the cord on the floor to ensure it is out of the baby's reach.
• The Sensor Pad works with all baby bed sizes and all mattresses, except memory foam mattresses or mattresses with a hollow frame. You will need to test your Sensor Pad after
the set-up is completed.
• The Nursery Unit can also be installed on a tripod (not included).
INCLUDED
3 AAA rechargeable
Sensor Pad
batteries for Parents Unit
Secure the Sensor Pad cord
Sensor Pad
2 AC adapters for Nursery Unit
and for Parents Unit charger
Masonite fiberboard
(not included)
3
Owner's Manual
Keep instructions for future reference
NOT INCLUDED
3 AAA regular batteries for
Hard fiberboard
Nursery Unit battery back-up
(Masonite)
Mattress
Sensor Pad cord
E
N