Water Separator - Drain Water; Water Separator Element - Replace - Mitsubishi S6R2 Operation & Maintenance Manual

Water Separator - Drain Water

1. Prepare a plate, and place it under the drain cock
of water separator.
2. Open the drain cock, and drain water in the water
separator.
3. Close the all drain cocks after draining.
Note: If the specification of water separator differs from
the contents of this operation manual, follow the
manufacturer's operation manual.

Water Separator Element - Replace

Open the inlet valve slowly to prevent overflowing fuel. Wrap a cloth around the water separator before the fuel
may spill.
1. Close the inlet cock and outlet cock.
2. Turn the T-handle, and remove the water separator
cover.
3. Open the drain cock, and drain fuel in the water
separator.
4. Close the all drain cocks after draining.
5. Replace the element with a new one.
6. Fill the water separator with fuel.
7. Attach the water separator cover, and tighten the T-
handle.
8. Open the inlet cock and outlet cock.
9. After replacing the element, open the fuel feed
valve to the engine, then bleed air from the fuel
system.
Note: (a) For bleeding fuel system, refer to
tem - Bleed Air"
(b) If the specification of water separator differs
from the contents of this operation manual,
follow the manufacturer's operation manual.
Chapter 8 PERIODIC INSPECTION AND MAINTENANCE PROCEDURES
"Fuel Sys-
(3-2).
Outlet cock
Fig. 8-5 Water Separator - Drain Water
Outlet cock
Drain cock
Fig. 8-6 Water Separator Element - Replace
Inlet cock
Drain cock
Element
Inlet cock
8-7