Reading The Indicators - Epson EB-L1105U User Manual

Reading the Indicators

This projector has the following five indicators to indicate the projector's status.
The following indicator status are used during regular operation.
Indicator
Power Status Laser
supply
Blue - On Off Off
Blue - On Blue - Status
Flashing varies
Projector's Sta-
tus
Temp Filter
Standby condition
Off Off
Network monitor‐
ing status
Warm-up status
Off Off
A
Power indicator
Indicates the projector's status.
B
Status indicator
Indicates the projector's status.
C
Laser indicator
Indicates the light source status.
D
Temp indicator
Indicates the internal temperature status. This is normally turned off.
E
Filter indicator
Indicates the air filter status. This is normally turned off.
Power is being supplied to the projector. In this status, you can start projecting by pressing the [
on the remote control or control panel.
(Sometimes, when the power cord is unplugged, the power indicator remains lit for a short period, but this
is not a fault.)
The projector is being monitored and controlled over a network (when Standby Mode is set to
Communication On).
If the power cord is disconnected and then reconnected in this status, the power indicator flashes blue.
This is the status immediately after turning on the projector. Warm-up takes approximately 30 seconds
after the light source turns on.
The [t] button is disabled during warm-up.
Explanation
157
] button