When Setup Fails - Epson EB-L1105U User Manual

Batch Setup
a
When using OS X, perform "Remove EPSON_PJ".
When all of the indicators start flashing, the settings are being
written.
Caution
Do not disconnect the power cord from the projector while the settings
are being written. If the power cord is disconnected, the projector may
not start correctly.
When writing completes normally, the projector enters standby
status.

When Setup Fails

The Indicators notify you if an error occurs. Check the status of the
indicators.
Status of the Indicators
Laser: Orange - flashing fast
Temp: Orange - flashing fast
Power: Blue - flashing fast
Status: Blue - flashing fast
Laser: Orange - flashing fast
Temp: Orange - flashing fast
Remedy
The batch setup file may be corrupt, or the USB
flash drive may not be connected correctly.
Disconnect the USB flash drive, unplug and then
plug in the projector's power cord, and then try
again.
Writing the settings may have failed and an error
may have occurred in the projector's firmware.
Stop using the projector, remove the power plug
from the electrical outlet, and contact your local
dealer or the nearest address provided in the Epson
Projector Contact List.
Epson Projector Contact List
s
153