Electrolux EVE636 User Manual page 63

TROUBLESHOOTING
NOTE: We may charge for service even in the warranty period if your problem is due to the causes listed below.
problem
Oven or grill not working
Oven light not working
Oven not heating enough
Clock flashing on display
Unit smoking when first used
Condensation build up
Door cannot be replaced after removal
Functions and temperature appear on
display but oven does not work
When the door is open the fan stops
(underbench only)
When a non fan mode is selected the
fan starts
The light stays on when the door is closed
The light does not turn *ON* when the
door is opened
Error message "REMOVE FOOD PROBE"
after connecting Food Probe to appliance
Food Probe temperature setting
not displayed
When using the Food Probe, centre of the
food is undercooked
Shelf or telescopic runner slides out when
door is opened
Door locked (switching off Pyro function
quickly)
Lime scale residue on base of oven
Oven seal loose
possible cause
• Time of day is not set.
• Power is not turned on.
• Controls are incorrectly set .
• Oven is in 'Demo' mode, refer to Additional Functionality.
• Household fuse has blown or power supply is off. (If the household fuse continues to
blow, call the Service Centre).
• Child-proof oven lock is activated. 'LOCKED' is displayed when control is touched.
(Refer to operating instructions).
• Light may be turned off at control panel.
• Lamp blown or loose socket.
• Household fuse has blown. (If the household fuse continues to blow, call the
Service Centre).
• Foil trays on bottom of oven.
• Timer is in 'AUTO' mode. (Refer to operating instructions).
• Household fuse has blown or power supply is off. (If the household fuse continues
to blow, call the Service Centre).
• Reset time of day and any cooking functions you were using.
• Protective oils being removed.
• Reduce the amount of water used in cooking. (Sometimes condensation
is normal).
• Stirrup not engaged properly.
• Oven is in 'Demo' mode, refer to Additional Functionality.
• This is a function of the power board to help reduce the blast of air when opening the door.
• Most oven modes have a fast heat up function that uses the fan, fan element and top
(boost) elements. Auto fast heat up can be overridden by selecting a temperature of
120°C or less, allowing the function to start, then increasing the temperature to the
desired level.
• An oven function has been selected.
• The light has been turned on at the control panel.
• Oven light may need replacing.
• The cooking function selected is not compatible with the food probe. Refer Food
Probe instructions page.
• Ensure Food Probe plug is fully inserted into the socket on the front panel.
• Incorrect Food Probe used. Only use the Food Probe recommended for
this appliance.
• Ensure food is fully defrosted
• Ensure the Food Probe is inserted at least 75% into the food.
•
Ensure that food has been adequately rested after cooking.
•
Oven cavity is not level, you can perform a check using a level to verify this (refer to
installation section). If not level refer to installer.
• Go back into Pyro mode and switch off Pyro function after few seconds for
to open completely.
• Follow the procedure for cleaning the cavity well. There may be some minor
residual marks after cleaning.
• The oven seal of non pyrolytic models is only attached at each corner. It may
seem like a loose fit, but when the oven is closed it will function correctly.
63
the lock